I need clear,concise, directions on how to make inside mitred cuts for moldings...base board and chair-rail. Pictures if available. Thanks for any help
Search these forums instead for instructions how to do coped corners. Coping is the right way to do it, and it has been covered here before. scroll down
Coping is "ONE" way to do it, but certainly not "THE" way or the "ONLY" way, nor even the "BEST" way...
There are MANY other methods including simply mitering at 45 degree inside and outside angles....and if you need 'pictures' for these, you need to be hiring someone else to do yur 'mitering' for you....
Post a reply as Anonymous
Related Discussions
Chair Rail
I am about to install a chair rail in an old home. The walls are plaster and not very plumb or straight. My concern is that I wont b...
1
answers
almost 16 years by Piffin
Chair Rail
How can I cut chair rail already mounted up on the wall? The previous owner made a cut 45 degrees at the outside corner instead of a...
1
answersabout 19 years by Jay J
Putting chair rail on rounded corners
I have added chair rail in my dining room and cannot figure out how to put it on the rounded corners - any suggestions?
1
answersabout 18 years by DH
What is this
I have a bug guy and a termite bond.....what is this????
0
answersabout 17 hours by BV022907
