Hi,

**665 15791793**

A Whirlpool built Kenmore.

**hat leaks around the bottom of the door, as soon as it fills up and starts its cycle**

Split spray arm, split/cracked pump cover, too much water, suds in the d/w ( wrong soap, from rince aid ), bad door gasket, bent door hinges, bad door lock are some common trouble makers.

http://www.applianceaid.com/dishleaks.html

jeff.

Appliance Repair Aid

http://www.applianceaid.com/

JRAppliance

http://www.jrappliance.ca

Thanks for the info. another question. was checking the lower spray arm , and the whole assembly is kind of flopping around on there. Checked nut and its tight, but radial bearing that fits on nut doesnt look like the picture in my parts page. Mine is just a flat washer type deal. Is that normal or could this be worn down and causing spray arm to flop around, thus causing my problem.

G'day,

**was checking the lower spray arm , and the whole assembly is kind of flopping around on there.**

It does move up and down a fair bit.

**Checked nut and its tight, but radial bearing that fits on nut doesnt look like the picture in my parts page. Mine is just a flat washer type deal.**

Looks more like a small T.

http://tinyurl.com/lrw6q

http://tinyurl.com/qg5an

You can see it above.

**could this be worn down and causing spray arm to flop around, thus causing my problem**

This will definetly not help!

jeff.

Appliance Repair Aid

http://www.applianceaid.com/

JRAppliance

http://www.jrappliance.ca

mine is leaking through the door latch up at the top of the door-- not the sides or the bottom