I have a Maytag Neptune: MAH5500BWW.
I am the process of replacing the outer basket bearings.
I popped the bearings out, that was easy. However, when I took the bearing spacer out and cleaned it up, I noticed that one of the ends has tappered edges.
I'm guessing that the tappered end of the spacer should rest against the smaller bearing.
Does anyone know if this is correct?
Also, I am trying to order the seal kit, and it is backordered. Does anyone know how to get one of these kits faster?
Get Help from Bob Vila
- Give-Aways & Offers
- Monthly Must Do's
- DIY Project Ideas
- Step-by-Step Guides
- Inspirational Photo Galleries