Have you tried the TimberLine wood fired water stove. They are meant to heat hot tubs and pools. They come in three different sizes and have added safety features such as built in temp gage and a pressure release valve. Their large wood fire pool heater is ideal for anyone that has wood at their disposal.
03:44AM | 05/10/13
Looks good thanks! Greetz https://addons.mozilla.org/nl/firefox/addon/seo-status-pagerankalexa-toolb/
03:45AM | 05/10/13
thanks a lot for reading. Greet from holland. http://www.zwembadverwarming.org/
07:22AM | 05/30/13
Thanks for sharing such a nice information..this will work as a normal temperature
Swimming Pool Heaters
06:40AM | 06/03/13
hye, i' m peter from FRANCE i dont know a lot of English just some memory of schoolfrom 25 years !!
i also try to heat my pool with wood but i put the copper coil into a drum full of water then putit in the fire ; it work but not as i wish.Did you put copper directly in fire ?
If you have got photos it will be nice.
Thank you in advance
my E.mail: [email protected]
10:33AM | 09/04/13
Hi just read about what you have done and it sounds very good could you please email me some pics please ? [email protected] thank you
New to the forum. I'am building a wood fired pool heater using a old fisher wood stove. will be using stainless steel pipe mounted to the inside top of the stove. Here is my question?. many people doing this use 50-100 ft or more of copper tube i guess the stuff you buy from home depoit or such. people say some problems are, making sure the water never gets cut off or it could melt the tube or the soilder. plus others have said it put strain on your pump going down to 1/2" in size. I was going to use 1 1/2 stainless sch 40 to do two things. #1 it wont hurt the flow rate. and #2 someone had mentioned its better to have more flow not so hot but heating a larger quanity. So which is more correct? lots (like 100') of 1/2" copper tube or lets say 24' of 1 1/2 stainless pipe. thanks for any advice my name is dave
11:44AM | 04/09/17
hi all hope someone may be able to help i have a WSP Siverdome wood burning stove that doesnt appear to be heating the water i have had a fire burning for 5 hours but there is no change in the temperature of the water I am at a loss to why
I have attached a pic of the set up at the inlet and outlet on the burner..there are a couple of what may be drain plugs above the inlet and outlet im wondering if these need to be opened or closed to allow the water to circulate within the woddburner