Latest Discussions : Tools & Workshop

hobodewey

11:21AM | 09/18/08
Member Since: 09/17/08
3 lifetime posts
Anyone know how to gain access to the power cord inside the arm?? I have to replace the power cord but have been unable to remove the top cover to gain access to the cord inside of the arm.

Model 113.199250 Craftsman 10" Radial Arm Saw

doug seibert

12:27PM | 09/18/08
Member Since: 08/10/02
842 lifetime posts
If you go to sears parts direct and type in your model # you'll get the parts list and exploded views.......

http://www.searspartsdirect.com/partsdirect/index.action

When I go there I see the UNIT exploded view shows a removable cover/trim....two screws..... facing the rear wall.....the power cord/strain relief appear to pass thru this cover....top ?

On this same page to the RIGHT...."Manage".....Click It ....register and yadayada get the PDF manual .....(page 37)

"......measure Once.....cut Twice....

throw that one away and cut a new one...."

hobodewey

03:40PM | 09/18/08
Member Since: 09/17/08
3 lifetime posts
The power cord does enter the rear of the saw but exits into a hollow area outside of the arm. It then enters the middle of the arm a few inches from the rear and includes the curly cord that goes to the motor. I need to remove the trim assembly, #9 and #10 in the manual diagram. I can't find any attachments, bolts, screws or the such which holds it down. I tried to pry it off but it just bends.

any suggestions??

Dewey

doug seibert

02:16AM | 09/19/08
Member Since: 08/10/02
842 lifetime posts
I don't own the saw .....But after reviewing the exploded view again......

......Remove the front-arm-trim pieces(#20-21-22-23)

.....and Then SLIDE the top cover #9 forward off of the arm......then lift #10..........

"......measure Once.....cut Twice....

throw that one away and cut a new one...."

BV007650

04:01PM | 04/26/15
I guess I own an older saw. Mine is 113.19770. Nothing in the forum I've seen helps me. I just want to replace the power cord but don't know how to access it. Don't see how to remove the "trim assembly." I have the manual but looking at the exploded parts doesn't help.


Post a reply as Anonymous

Photo must be in JPG, GIF or PNG format and less than 5MB.

Reply choose button

Anonymous

Post new button or Login button
Register