Latest Discussions : Tools & Workshop

mmolinaro

08:48AM | 01/23/05
Member Since: 01/22/05
1 lifetime posts
This is my first attempt at crown molding. For my first piece going from inside corner to inside corner, do I need to cut a mitre angle at each end, or can I leave one end flush to the corner?

I think I must mitre cut both ends because it is unlikely that each corner is a perfect 90 degree angle, correct?

Altereagle

10:28AM | 01/25/05
Member Since: 12/27/02
543 lifetime posts
It will depend on how you will be handling the inside corners.

If you are planning on coping you would cut that corner straight and then 45 & cope the other side.

There is a tutorial I put on my site for cutting crown moulding if you were interested?

http://www.altereagle.com/How_to_install.html

http://www.altereagle.com/

http://decks-ca.com

http://kingofcrown.com

Alter Eagle Construction & Design


Post a reply as Anonymous

Photo must be in JPG, GIF or PNG format and less than 5MB.

Reply choose button

Anonymous

Post new button or Login button
Register